Ovens are supposed to bring ease and properly cooked food, but people often struggle with the oven not working at all. In the majority of cases, people replace the oven elements since they are termed the most common reasons behind the oven not working or heating.
However, if you replaced the oven element and it’s still not working, there are chances that some other components are faulty. So, if you can relate to this issue, we have some solutions lined up for you!
How to Fix Replaced Element Oven Still Not Working?
1. Faulty Temperature Sensor
When it comes down to the electric ovens, they are designed with a temperature sensor which is responsible for monitoring the oven’s interior temperature when it’s switched on. Consequently, if the temperature sensor has been damaged, it will fail to heat up the oven or maintain the temperature.
On the other hand, if your oven doesn’t have a temperature sensor, you should be looking for the temperature-sensing blub. This is because when the bulb comes off loose or burns out, the oven won’t be able to heat up. As far as the solutions are concerned, the temperature sensor needs a replacement (repairing won’t work), and the bulb needs to be tightened up. However, if the bulb has burnt out, it will need a replacement as well.
2. Oven Igniter
If you replaced the oven element because the oven wasn’t heating up, but the issue is still there, you have to consider the oven igniter. Keep in mind that you will need to be careful, and the oven needs to be switched off. Once it’s switched off, check at the back of the oven to find the igniter. When you locate the igniter, remove it, and use the multimeter to check if it has continuity. If it doesn’t register below 1100-ohms, the igniter has gone bad and needs a quick replacement.
3. Selector Switch
This is another component that you must consider when the oven stops working and replacing the oven element didn’t work. For those who don’t know, the selector switch is responsible for supporting the change in oven settings. That being said, when the selector switch is damaged, it won’t allow you to change the settings and will be fixed by replacing the component. For this reason, just take off the knob, unscrew the selector switch, and screw on a new one.
The selector switch is easily available online but make sure that you purchase a specific selector switch that’s designed for your oven (do check the oven’s model). To summarize, if you want to be on the safer side, just replace the thermostat as well as the selector switch.
Sure, you have replaced the oven element, but if that hasn’t worked out in your favor, it’s time you check out the relays. This is because when the relays stop working, the oven won’t be able to heat up properly. As for the relays, they are as much as the heating elements in the oven (if your oven has two heating elements, there will be two relays, and so on). Over time, the relays can wear out but replacing them is quite a challenge. People try to change relays on their own, but since it’s challenging, hiring a professional technician would be better.
When the oven fails to operate after all these solutions, there are chances you have set incorrect calibrations. The calibration dial and settings are different for every oven, so you will need to check the product manual. When you locate the dial, you can use the screwdriver to adjust the temperature and calibrate it. Also, when you turn the screw in a clockwise direction, the temperature will increase, and vice versa. For more precise assistance, use the manual or call the customer support of the oven manufacturer, and they will walk you through the process.
6. Electronic Control Board
If you are using some advanced model of the oven, it’s highly likely that you have an electronic control board in there. The electronic control board is the oven’s brain since it controls and manages the broil functions and baking functions. However, when electricity stops flowing through the electronic control board, it won’t operate, and the oven’s functionality will be restricted as well. So, get the electronic control board checked by some professional!