The next thing to check is the path that your water hose takes. Blockages occurs frequently in this type of machine. Over time mineral buildup will restrict the water from flowing.
Make sure there is nothing blocking your water hose. Without water flowing through your tubing, it won’t be able to brew at all. No special tools is needed here, just a simple screwdriver will do if you can see some debris.
Inspecting Internal Components
You can clear out visible debris with a basic screwdriver because no special tools is required.
Also check to see if your hose is firmly seated in the port located on the main body. Remember, air is leaking out when the hose isn’t tight. Make sure this part is tight enough to push water into the line. Gently tug on it to ensure it’s holding secure.
If all seems well there, let’s continue.
You should also verify that the hose is seated tightly in its port at the main body. Loose connections cause air leaks and pressure loss, so the hose need to be secure to push water upward. You can give it a gentle tug to confirm it holds firm. If everything looks connected properly, you can move on to the next step.
If you take your machine out and it no longer hums, the water pump might be at fault. This is what pushes water from the reservoir to the heating element. Find the pump, which should of being located in the chassis next to the circuit board.
You should locate the pump inside the chassis next to the circuit board.
Before you start suspecting any of the above, check your pump to see that it’s working.
One other thing you’ll want to check is that little hole in the bottom of your water tank (that’s how the water comes into the machine). Scale and/or other debris may be blocking the inlet and preventing the pump from drawing any water. Clear it out and make sure there’s good flow through that opening into the heating chamber. It’s an easy mistake that will completely halt the process.
To use, the basket needs to be properly seated on the shower head (if not), the shower will break the flow path of water. Take the basket off and put it back on so that it lines up with the showerhead. Water should disperse across all the grounds evenly when properly seated.
The brewing basket must be seated correctly to function because it breaks the flow path if it is not locked into place.
Make sure it’s snug. That confirms the install.
Use the original kettle made by Black & Decker. Other kettles may not fit well or engage with the release mechanism properly. If they do not fit, coffee might fall out while brewing.
Make sure the kettle sits snug so water can flow through into the coffee grounds. The performance of this thing make a big difference if you get the right part.
You should use the genuine Black & Decker kettle because non-original versions often fit poorly.
Followed those steps and voilà, problem solved for you and the coffee maker is alive once more. It started pumping water again and brewed like normal.
Turns out all it took was some care. Your coffee maker wasn’t dead; it simply needed some love. Use these troubleshooting tips next time something happens and you think you’re done with your coffee maker.