The GE Profile ovens are known for reliable functionality, and there are only a few ovens with such amazing features and performance. However, this is all great unless your GE Profile oven will not heat up past 100 degrees. Still, the problem is quite easy to fix, and we have all the solutions to help you get the oven back on track!
GE Profile Oven Will Not Heat Up Past 100 Degrees
1. Defective Heating Element
When the oven is not heating past the 100-degrees temperature, there are chances of a defective heating element. Since the GE Profile oven is an electronic model, it will have two elements – one for broiling and one for baking. So, when any of these heating elements start glowing red, it is a clear symptom that the heating element is not working or it’s been damaged. To fix this problem, you could follow the instructions mentioned below;
- If the element is not working, it will glow extremely red, and nothing will resolve the matter unless you replace the heating element
- Always call a technician for replacing the heating element in the oven to ensure you don’t leave out the loose wires
2. Wiring
If you have already checked the heating element and it’s been replaced, but the oven still won’t heat, there are high chances of electrical issues. For this purpose, you can opt for a voltage meter for testing the wires that are connected to the heating element. This is because some wires could be damaged or might have come loose, resulting in the ineffective functionality of the heating element. So, just use your voltage meter for testing the terminal wires and fix the wires, if needed.
3. Temperature Sensor
The GE Profile oven is integrated with the temperature sensor that helps monitor the internal temperature of the oven. On the other hand, when the sensors are damaged, there will be a bad influence on heating. It is pretty obvious that you need to replace the sensors, but for that, you have to ensure that the oven elements and wiring are on the top. Once done, you can go ahead with the sensor replacement and get the heating optimized.
On the contrary, if the GE Profile oven doesn’t have a sensor, you can opt for a temperature-based bulb for controlling the oven temperature. In such cases, you must ensure that the bulb is not burnt out or loose. In any such case, you have to replace the bulb. In any case, it’s best to call a professional to get the temperature sensor or bulb replaced.
4. Igniter
Another potential solution to your oven’s heating issue is the igniter. However, before you start playing with the igniter, make sure that the oven is disconnected from the power and move on to remove the igniter from the back. When the igniter is out, you can use the multimeter for detecting the power continuity, and it needs to be anything between 0 ohms and 1100 ohms. However, if these numbers don’t show up on the igniter, the igniter is not working properly and should be replaced.
5. Selector Switch
The selector switch is also known as a thermostat, and it needs to work on point to ensure the oven heats past 100-degrees Fahrenheit. However, when the selector switch is burnt, the heating will be impacted because it’s responsible for changing the settings. So, change the selector switch, and we are certain it will get the heating back on track.
6. Calibration
Calibration is another issue associated with the heating issue. In various cases, calibration can result in excessive heating, but it also leads to insufficient heating. For resolving this issue, you must identify the calibration dial as well as the adjustment screw. Then, you can use the screw for increasing or decreasing the temperature. For increasing the temperature, the screw should be turned counterclockwise but reducing the temperature needs clockwise turning. All in all, in your case, you have to turn this adjustment screw in a counterclockwise direction and increase it by 25-degrees.
7. Relays
The last solution is checking the relays because damaged relays can result in ineffective heating. In case your oven is integrated with two heating elements, it will also have two relays, and they tend to burn out with time. So, just get the relays checked and fix them.